Dynisco 1490 1/8 User Manual

From lab to production,
providing a window into the process
-13-
www.dynisco.com
Rev: n/aP/N: n/a ECO: n/a
Note: CHH], CLL] or OPEN may also be displayed if an incorrect input type is selected.
8. Operator Mode
This mode is entered at power on, or accessed from Select mode (see secon 2).
Note: All Conguraon mode and Setup mode parameters must be set as required before starng
normal operaons.
Press to scroll through the parameters (while this key is pressed, and for 1 sec aer, the
parameter legend is shown, followed by the current value).
Note: All Operator Mode parameters in Display strategy 6 are read only (see diSP in conguraon
mode), they can only be adjusted via Setup mode.

Dynisco 1490 1/8 Specifications

General

Brand	Dynisco
Model	1490 1/8
Category	Touch Panel
Language	English