Power Vision Quick Start Guide - 11
FLASHING A DYNOJET PRE-CONFIGURED TUNE FILE
• Select Program Vehicle. • Select Dynojet
Pre-Configured Tunes.
The Power Vision will automati-
cally search for compatible tunes.
• Select a Dynojet Pre-Configured
Tune File to flash.
• Touch Select.
• Verify the tune information. If
the tune information is correct,
touch Continue.
• Select a slot to save the selected
tune file.
Note: If there is any data
in the selected slot, it will
be overwritten.
• Touch Select.
The tune is now ready.
• Select Flash to flash this tune to the ECM.
Note: During the flash process, do not
turn off the bike. Once complete, you will
be prompted to turn the bike off for 10
seconds.
• Select Edit to edit this tune.
• Select Exit to exit the screen without
any changes.
• Select Load Tune.
Note: You can edit any tune that’s loaded in the Tune Manager prior to flashing your ECM. The Power Vi-
sion allows you to make basic adjustments to your tunes directly on the device without using a computer.
In order to gain full access to your tune files, you’ll need to download them from the Power Vision to WinPV,
our custom tuning software.
Use the following steps to flash a
Dynojet Pre-Configured Tune to the ECM:
To Next Page
Loading...
Need help?
General
