98100014.07 Toll Free: 1-800-992-4993
• Select Program Vehicle. • Select Custom Tunes.• Select Load Tune.
The Tune is now ready.
• Select Flash to flash this tune to
the ECM.
Note: During the flash process,
do not turn off the bike. Once
complete,
you will be
prompted to
turn the bike
off for 10
seconds.
• Select Edit to edit this tune.
• Select Exit to exit the screen
without any changes.
Note: You can edit any tune that’s loaded in the Tune Manager
prior to flashing your ECM. The Power Vision allows you to make
basic adjustments to your tunes directly on the device without
using a computer. In order to gain full access to your tune files,
you’ll need to download them from the Power Vision to WinPV,
our custom tuning software.
• Select a Custom Tune File to
flash.
• Touch Select.
• Verify the tune information. If
the tune information is correct,
touch Continue.
FLASHING A CUSTOM TUNE FILE
Custom Tunes may or may not be pre-loaded from a reseller that specializes in
custom tuning. Dynojet does NOT load custom tunes in the Power Vision when it
leaves our facility (we load Dynojet Pre-Configured Tunes). You may also receive
Custom Tunes via email that can be uploaded to the Power Vision using WinPV, our
custom tuning software.
Use the following steps to flash a Custom Tune file to the ECM:
To Next Page
Loading...
