Power Vision Quick Start Guide - 13
The Tune is now ready.
• Select Flash to flash this tune to
the ECM.
Note: During the flash process,
do not turn off the bike. Once
complete,
you will be
prompted to
turn the bike
off for 10
seconds.
• Select Edit to edit this tune.
• Select Exit to exit the screen
without any changes.
LOADING A COPY OF THE ORIGINAL TUNE FILE,
OR A COPY OF THE CURRENT TUNE FILE
• Select Program Vehicle.
The Power Vision will allow you to use either a COPY OF ORIGINAL tune or a
COPY OF CURRENT tune files.
The COPY OF ORIGINAL tune file is a copy of the tune that was present in your ECM when the
Power Vision first locked to your ECM. In other words, it is a copy of the backup file that was
created and stored in the Power Vision. This is a great way for those who are happy with the
way their bike runs, but want access to their existing tune in order to make a few adjustments.
The COPY OF CURRENT tune file is a copy of the CURRENT tune that has been flashed to
your ECM.
Use the following steps to load and flash either a Copy of Original tune
or a Copy of Current tune file to the ECM:
• Select Load Copy.
• Select a slot to save the Copy
of Original tune file.
Note: If there is any data in
the selected slot, it will be
overwritten.
• Touch Select to continue.
• Select the type of tune you want
to copy.
You may either select to Load a
Copy of the Current Tune or a
Copy of the Original Tune into
the tune manager.
• Select Load Tune.
Note: You can edit any tune that’s loaded in the Tune Manager prior
to flashing your ECM. The Power Vision allows you to make basic
adjustments to your tunes directly on the device without using a
computer. In order to gain full access to your tune files, you’ll need
to download them from the Power Vision to WinPV, our custom
tuning software.
To Next Page
Loading...
Need help?
General
