Information menu
Assembling your machine
Getting started
Standby on/off
Airflow speed
Place the remote control on top
of the machine with the buttons
facing down.
Plug in and switch on.
Remote control
Night modeOscillation on/off
Auto mode Cooling mode
Heating control
Dyson Purifier Hot+Cool Gen1
Supplied with a combined glass HEPA+Carbon filter.
Amplifier loop
Standby on/off
LCD screen
Filters (inside)
Shroud
Shroud release buttons
Use both hands to lift your machine out of the box, by its base.
Do not lift out by the loop amplifier.
An image of the air purifier fan
heater with the remote placed on
the top of the loop amplifier and
the location of the standby on/off
button on the top of the base of
the machine.
The layout of the remote control with the standby button on the top left,
the airflow speed toggle button in the middle left with the Auto mode
button below and then at the bottom is the Oscillation button. On the top
right-hand side is the Information menu button, then going downwards is
the Heating control button, Cooling mode button and then Night mode
button at the bottom.
To Next Page
Loading...
