Auto mode
Oscillation
Press the Oscillation button to circulate the air around the room and scroll
through the oscillation settings from 0°to 350°.
Airflow speed
Press the Airflow speed button to increase and decrease the airflow speed.
Set your Dyson purifying fan heater to Auto mode and the on-board sensors will
intelligently adjust the settings of the machine according to the air quality.
Air quality: your machine will pause when the target air quality has been reached,
switching on again when the air quality levels drop.
Airflow speed: the airflow speed will increase until the target air quality and
temperature have been reached.
The remote control with
the Auto mode button
below the Airflow speed
button on the left.
The remote control with
the oscillation button
on the left at the bottom
below the Auto button.
The remote control
with the Airflow speed
toggle button on the
left hand side, below
the standby button.
To Next Page
Loading...
