Changing your HEPA+Carbon filter
Supplied with a HEPA+Carbon filter.
To change your HEPA+Carbon filter, push down on the buttons
either side of your machine to release the outer cover. Push down
on the tabs to remove the filter.
Push the replacement filter into the outer cover and make sure the
tabs click into place.
Put the outer covers into position on your machine and push firmly
until they both click securely into position.
Plug in and switch your machine, and reset your filter life.
Resetting your HEPA+Carbon filter life
Resetting your HEPA+Carbon filter life
It's important to reset your filter life after you have replaced your filter.
Press and hold the Night mode button on your remote control.
The display on your machine will countdown from five,
the filter life will be reset and your machine is ready to use.
5
sec
Before changing your filter, switch off and unplug your Dyson purifier
fan heater.
The remaining filter life is displayed on the screen and will indicate when
your non-washable filters need replacing. Press the Information button on
your remote.
You’ll need to reset the filter life on your machine.
Dyson Purifier Hot+Cool Gen1
The air purifier fan heater with the filter covers
open showing a HEPA plus carbon filter located
in the filter covers. Arrows demonstrate that the
filter covers will need to be assembled onto the
base of the machine.
Pressing the Night mode
and Sleep timer button
on the bottom right of
the remote control for 5
seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
