Dyson purifier hot+cool gen1 User Manual

Looking after your machine
Error codes
Cleaning your machine
To always get the best performance from your Dyson purifying fan
heater, it’s important to regularly clean it and check for blockages.
If your machine is dusty, wipe with a damp lint-free cloth.
Look for blockages in the air inlet holes on the filter and the small
aperture inside the loop amplifier.
Use a soft brush to remove dust and debris.
Don’t use detergents or polishes to clean your machine.
If your machine shows an error code, try turning it off and then on again.
If this doesn’t clear the error code contact Dyson Customer Care.
For more information and support for your machine go online:
www.dyson.com/support

Dyson purifier hot+cool gen1 Specifications

General

Airflow	290 l/s
Cord length	1.8 m
Automatic mode	Yes
Air purify rate	- m³/h
Number of speeds	10
Oscillation angle	350 °
Air purifiers functions	Cooling, Heating
Noise level (low speed)	40 dB
Noise level (high speed)	63 dB
Timer duration (maximum)	8 h
Timer duration (minimum)	1 h
Suitable for room area up to	- m²
Package width	280 mm
Package height	823 mm
Package weight	7180 g
Battery type	CR2032L
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Power consumption (max)	2362 W
Power consumption (standby)	1 W
Fine particle (PM2.5) numeric reading range	12 µg/m³
Display type	LED
Product color	White
Filter life (max)	12 month(s)

Weight and Dimensions

Depth	131 mm
Width	205 mm
Height	765 mm
Weight	5290 g
Remote control weight	25 g
Remote control dimensions (W x H x D)	32.2 x 10.49 x 101.9 mm