E.C.A. CA 24 BB - Boiler Start-Up

- BOILER START-UP
• Final Checks And Operations
~ Information
Having completed the installation and connections (flue, electricity
supply,
gas supply and water circuits) of the boiler according to
the authorized gas company regulations and relevant standards,
the final checks and operations must be carried out by qualified
person.
Filling the boiler and central heating circuit with water.
-
Firstly, turn on all the radiator valves.
-
Check inlet and outlet CH valves. The valves must be open.
-Remove the front panel, combustion body cover (in room sealed fan assisted boiler) and
right side panel respectively.
-Open manual air vent on heat exchangerl ).
- Open filling tap2) slowly to fill the system.
-Turn
off the air vent on heat exchanger when water starts to squirt.
- Keep
up filling until water pressure measures l ,5 - 2 bar on the thermomanometer.
-
Turn off the filling tap.
A CAUTION: Do not forget to turn off the filling tap, water can
~ leak and cause damage.
-Turn on the air vents to set air free until water squirts. Repeat this process for all the radiators.
-Check the CH water pressure on the thermomanometer again, and turn on the filling tap
to increase water pressure to l ,5-2 bar level.
-Check radiator vents whether any air in the water pipes or not. Air must be purged out
entirely for efficient heating.
-
Check any leakage in the radiator and the water pipes finally.
[]] Open hot water tap to check DHW circuit. Check any leakage water pipes.
[}] Check whether flue kit is comprised of original parts or not according to the instructions
and regulations.
In addition,
> Electricity connections of boiler must be earthed and suitable with main supply conditions
(230 V
AC- 50 Hz).
:.. Gas supply must be checked by the qualified gas company.
Call qualified service to boiler start-up after all these processes ore completed.
~ Bo;to, . <lad~p mu<l bo pcdonnod CC<lainly by qualified peNon.
~Information
After boiler start-up, you should request information about
operating
the boiler and safety precautions from qualified
person.
l) The manual air vent is on the top of expansion vessel in bitermic types (CA 24 BB - CA 24
HB).
2) The filling tap is not available in some models based on national and local regulations.
25