4. Secure the receiver to the fuselage under
the wing using hook and loop tape. Route the
antenna wires according to the manual provided
with your radio system. Plug the servos into the
appropriate positions in the receiver.
Note: Make sure all the wires are neatly taped
to the fuselage to prevent them from getting
entangled with the linkages.
5. Position a control horn on the aileron. The
horn will have the holes for the clevis in line
with the aileron hinge line, and fairly close to
the outer edge of the balsa. Mark the location
for the two horn posts using a felt-tipped pen.
27
To Next Page
Loading...
