E-FLITE Cap 232 BP 3D - Brushless ESC Information

 4. Slide the motor mount onto the motor stick. Use
a drill and 1/16" (1.5mm) drill bit to drill a pilot
hole for the screw into the motor stick. Use the
1.5mm x 10mm screw to secure the mount to the
motor stick.
Note: Check that your motor has right
thrust. The motor will be angled towards
the right when viewed from the top of the
aircraft as shown.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed
to Off. Also, be sure to use an ESC with the
proper 9V cutoff when using 3-cell Li-Po packs,
or 6V cutoff when using 2-cell Li-Po packs.
35