13
KXMANUAL
www.eaeelectric.com
www.eaeelectric.com
250mm
PE
L3
L2
L1
N
PE
L3
L2
L1
N
8
Installation
Mounting Instructions For Joints (Bolt-on / Plug-in)
PE housing
7-Adjust the channel in order to pivot the
alignment piece to the housing.
8-Push the two busbars until they rest on each
other.
11-If there is more than one bolt per phase,the
bolts should be tightened by hand to
approximately 20-30 Nm as per the sequence
shown above.Then nally torque to 83Nm using
the same sequence.
12-Remove the joint covers and reverse mount
them with the gaskets facing in.
9-Assemble both the joint covers with the
gaskets facing out.
10-Adjust the torque wrench to 83 Nm (60 lbft)
and tighten the joint nut.
7
9 10
83
Nm
11
1
5
2
6
3
7
4
8
İlk Torklama
(20 Nm)
Nihai Torklama
(83 Nm)
1
2
12
To Next Page
Loading...