EAE E-LINEKX - Mounting Instructions for Joints (Bolt-On; Plug-In)

12
KXMANUAL
www.eaeelectric.com
www.eaeelectric.com
Installation
Mounting Instructions For Joints (Bolt-on / Plug-in)
1-Align the two busbars so that the parts with
and without block joints are opposed.
5-Align the block joint to the other busbar's end.
1
3-Remove the nut locking piece on the busbar
joint and loosen the joint. Remove the protective
covers after loosening the joint.
3
4-Ensure that the insulation plates of the joint,
are not cracked, broken or damaged in anyway.
Wipe the conductor surfaces with a cloth to
clean dust, which can cause serious damage.
4
5
6-Loosen the nut at the joining point completely.
6
2- Remove the protective covers on the side with
no block joints.
2