27
KXMANUAL
www.eaeelectric.com
www.eaeelectric.com
Energizing The Equipment
Energizing
Energizing The Equipment
1- The equipment should be only energized by
authorised personnel.
2- There should be no electrical load on the
busbar system when it is energized.
3- Hazardous voltages in electrical equipment
can cause severe personal injury or death.
Energizing a busbar run for the rst time is
potentially dangerous. Therefore system
opertional voltage should be checked
4- The connected equipment should be
energized in sequence by starting at the
source to end of the system
5- After all overcurrent devices have been turned
on, loads such as lighting circuits, contactors,
heaters and motors may be turned ''ON''.
6- EAE busbar system is particularly quiet
when operating normally. In some installations
however there may be a moderate hum.
Excessive noise may be an indication of
hardware that has not been tightened or of metal
parts that have been improperly assembled and
this should be checked after de-energizing the
system and isolating it safety.
To Next Page
Loading...