Eagle Tree Systems Vector User Manual

USER GUIDE
35
Md
toggle Mode.
Hold Rudder Stick Left/Tog Md
Hold the rudder stick all the way left, and while holding, toggle Mode.
Flip Submode if Used/Tog
Mode
If you are going to use a Submode switch, move that switch to a new
position (don’t move it back) and toggle Mode. If you are not going to use
it, just toggle Mode without moving any switches.
Rotate Gain if Used/Tog Mode
Rotate the Gain knob to a new position (make sure that it moves at least
40% of its maximum turn) and toggle Mode. If you are not going to use it,
just toggle Mode without moving any knobs.
Kill switch on if Used/Tog
Md
If you wish to use a Kill switch for your multirotor, change its position
(hold it in the new position if it’s momentary) and toggle Mode. If you are
not going to use it, just toggle Mode without moving any switches.
Flip Flaps Sw if Used/Tog
Md
If you wish to use a flap switch or knob with the Vector, change its position
and toggle Mode. If you are not going to use it, just toggle Mode without
moving any switches.
Learn Done! Clik Md to reboot
The Vector has now learned your serial Rx mappings. Click the mode
switch to reboot, and continue with the steps below.
If you ever need to change your serial mappings later, just invoke the “Serial Rx Input Learn Wizard”
menu item in the Radio Control Settings menu.

Eagle Tree Systems Vector Specifications

General

Brand	Eagle Tree Systems
Model	Vector
Category	Controller
Language	English