n To Arm the system:
To Disarm the system:
SILENT DISARM: To hold button for over 2 seconds (in armed), light flash twice but no chirp sound, other
function are the same as Disarm.(This feature to prevent noise in silent area)
STANDARD FEATURES :
To arm your system within proper operation range, simply press button once. The
system will respond one siren chirp, one lights flash, doors lock, disable engine starter and controller to close all
windows . LED fash once per second to show the system is in arming mode.
SILENT ARM: To hold button for over 2 seconds (in disarmed), light flash one but no chirp sound ,other functions
are the same as Arm .(This feature to prevent noise in silent area)
DEFECTIVE ZONE BYPASS: If armed, the system responds extra siren chirps, it indicating that one of the zone is
not close properly. The different siren chirps to identify. (1)Chirps 4times: Door's not closed (2) Chirps 5times:
Trunk or Hood not closed. The system will bypass that zone and still protect other zones.
AUTO RESET: If a violation occurs the system will respond by sounding the siren and flashing the lights for
approximately 29sec. before the system resets itself and continues to protect your car. If violation still occurs the
system, siren and lights will working for 6 cycles then the system reset itself and continues to protect other zones.
n To disarm your system within proper operating range, simply press button
once. The system will respond two siren chirp, two light flash, doors unlock, enable your engine starter, LED off .
INTRUSION ALERT: Extra disarm chirps are the Intrusion alert. If the system is armed and the vehicle was
attempted or intruded. The unit will chirp 5 times and flash 5 times when disarming. The status LED flashing times to
indicates which was triggered, please see under table.
Quick flash 2 times after a pause Sensor 1st stage triggered
Quick flash 3 times after a pause Sensor 2nd stage triggered
Quick flash 4 times after a pause Door triggered
Quick flash 5 times after a pause Hood/Trunk triggered
Quick flash 6 times after a pause Ignition switch triggered
Panic Mode:
Auto Re-Arming :
n Remote Trunk Release: Press button: 2key ( ) / 3key ( ) / 4key( ) for over 2 seconds
then trunk will automatically opened , when system armed , if remote trunk release will not trigger alarm and sensor
detect will shut off ,but ignition switch and doors keep arming condition. After close trunk for 5 seconds , trunk and
sensor trigger will return to arm status.
n Press button: 2key ( ) / 3key ( ) once . or 4key( ) for over 2 seconds
If you are threatened in or near your vehicle, you can attract attention by triggering the system
with your transmitter. Press for 2 second, and you will enter Panic mode. The siren will sound and the parking
lights will flash for approximately 30 seconds. To stop Panic mode at any time, press any button once on the remote.
n If the system is disarmed by remote and a door is not opened within approximately 30
seconds the system will automatically rearm itself. This feature guards against disarming caused by accidental or
unintended operation of the remote transmitter. Note: itî˜ willî˜ notî˜ autoî˜ re-armî˜ ,î˜ ifî˜ aî˜ doorî˜ openî˜ withinî˜ thisî˜ 30î˜ secondî˜ mark.
*When triggering 2nd stage sensor: Siren/Horn and the parking lights will activate for 29 seconds.
*When triggering IGN, door, hood or trunk and etc. : Siren/Horn gives 29 seconds sound and light flash 29
seconds. After alarm triggering there is 2 seconds pulse. The alarm will detect to see if it is recovered to normal arming
condition. If it is not , the alarm will trigger again.
Remote Sensor by Pass :The alarm offers two stage sensor optional. Within 10 seconds after set
arming, to press button once, siren/horn will chirp twice ,thus the 1st stage sensor bypassed, to press button
twice, siren/horn will chirp 3 times, thus all sensors will be shut off and no sensor working for arming protection.
n Alarm Trigger :During arming, if turn on ignition, open door ,etc..alarm will trigger in order to stop the
offender.
*When triggering 1st stage sensor: Siren / Horn gives 1 long chirps to pre- warning.
n
n Valet mode : You can prevent your security system from automatically arming and triggering by using Valet
mode. This is very useful when washing the vehicle or having it serviced. In Valet mode, the security system will not
arm, even with the remote transmitter, but remote door lock / unlock willcontinue to work normally.
To enter or exit Valet mode: Turn the ignition on. Within 10 seconds, press and hold the Valet switch for over 5
seconds , the status LED will light ON to indicate that the system is in Valet mode.
On the contrary, exit the Valet mode, the status LED will light off to indicate that the system is in alarm mode.
n Emergency Disarm : In arming condition, if remote is lost or damaged, the owner can enter the car by
using the key to open the door , the alarm will trigger at this time. Turn Ignition ON and within 10sec, press and hold
Valet SW for over 5 seconds, the system will turn disarmed and into Valet mode.
n Passive arming :
(programmable )
This system also can be to arm itself automatically (called passive arming). If the system programmed for passive
arming, it will automatically arm 30 seconds after the ignition is turned off and the system "sees" you leave the
vehicle by opening and closing a door. Whenever the system is in its 30-second passive arming count-down, the
status LED will flash fast as it does when the system is armed. The system armed and the doors lock ( if programmed
with passive door locking) at the 30 second mark.
-3-
To Next Page
Loading...
