Eaglemaster LT-5200 - Anti Car Jacking

2 step disarm: This system offers 2 step disarm. It's a feature that make it possible to silence and reset the
system while it is triggering, without disarming the system. If the system is triggered and the siren has been sounding,
pressing any button once on the remote transmitter will stop the trigger and return the unit to the armed state.
Passive immobilizer : .If programmed with Passive immobilizer feature, after driving and turn off ignition
for 30 seconds or you open and close door in 30sec. The system it will disable the starter function right way. The status
LED will flash twice after a pulse. To disarm this function, simply press button once or turn Ignition on ,within 10
seconds press and hole Valet SW over 3sec. to disarmed.
2nd Killer Output: This feature can be controlled separately of the engine disable. This output (-500mA) is
working when system disarmed. 40A relay is required and go with 40A relay (N/O & COM) output connection required.
Power disconnecting Memory : Alarm is built in memory on main unit. Generally, after alarm unit power
is cut and reconnect, main unit will read back these data make the alarm to resume. When in disarm, arm or valet mode,
power off then on again, alarm will read back original position.
Safety Door Lock/Unlock :
Built Shock Sensor Sensitivity Adjusting : This system offer two stage shock sensor built in
main unit. You may adjust sensitivity when necessary. There are 10 scales for sensitivity adjusting : First scale means
the most sensitivity and last (the 10th) scale means the last sensitivity.
Factory default sets the sensitivity in the middle(5th scale).
1. Disarm the system , turn ignition from ON to OFF position and within 10 seconds, press and hold the Valet SW for
over 3 seconds. Until Siren/horn give 1-short and 1-long chirp to confirm enter in this mode.
3. Adjusting to more sensitive zone : to press button once , more over 1 scale to more sensitive side.
As a response, light will flash once and siren/horn will chirp once. If it is adjusted to the most sensitive scale, there
will be no more sound given.
4. Adjusting to less sensitive zone : to press button once , move 1 scale to the less sensitive side.
As a response, light will flash once and siren/horn will chirp once. If it is adjusted to the most sensitive scale, there
will be no more sound give.
5. During adjusting, you may push car for sensitivity testing : If it is suitable for 2nd stage setting, alarm will chirp twice
If it is suitable for 1st stage setting, alarm will chirp once.
6. To exit the mode by : Turn ignition ON or within 10 seconds there is no remote adjusting, nor push testing. .
Anti Car jacking : When driving the car, you can enter the anti car-jack mode by transmitter. Press button
2key ( ) / 3key ( ) once. or 4key ( ) for 2sec., The parking lights will start flashing to show the car is
entering anti-jacking mode . Please see under anti car-jack mode table.
Exit : To exit the anti car-jack mode, simply press button once will turn off the mode.
If set programmed with this feature (set by jumper 2) turn Ignition ON after
10 seconds the doors will auto locked , but within this 10 seconds the door has been opened this feature will be
cancelled. When turn Ignition OFF, the doors will unlock for take off service.
30
85
86
87a
87
2nd Immobilizer
relay
ALARM CONTROL UNIT
NegativePulsedoutput For
2ndImmobilizer
Extragraywire
CutExistinglow
currentfuelpump
wireorStart solenoid
Wire
Connect to Switched (+)
12Volts Ignition key on
Wiring for 2nd immobilizer
Parking Lights flash
Siren /Horn
Starter killer
2nd immobilizer
Timer
Sire npre -warnch irps
0sec. 25 sec. 50sec. 70sec. 90sec.
Parking Lights flashing once per second
Sire nsou nding
Starterd isab le
2ndimmobilizera ctive
-4-