Eaglemaster LT-5200 - Central Door Lock Wiring

CENTRAL DOORLOCKWIRING:
HOW TO USE CODE LEARNING :
This system can expand 4 different transmitters, and comes from factory with two transmitters
already programmed into the system memory. Whenever you want to add or delete transmitter code
of the system, the procedures are as following :
1. Disarm the system. Turn ignition switch to ON .
2. Within 10 seconds, press valet switch on-off for 5 times.
3. Siren/Horn will provide 1 long chirp to confirm the system is in code learning mode.
4.To press any remote button, code learning achieved if it gives one short chirp.
5.To turn off learning mode :
(1)Turn off ignition switch.
(2)Four transmitters have been successfully learnt already
(3) Within 10 seconds , there is no new transmitter be learnt.
Note: Every time learning new transmitter , formal code (old transmitter) will be erased, hence
you have to lean again .
-5-
Green/black
Green
Green/red
Blue/black
Blue
Blue/red
Green/black
Green
Green/red
Blue/black
Blue
Blue/red
Green/black
Green
Green/red
Blue/black
Blue
Blue/red
MOTOR CONTROL
MOTORCONTROL
UP
DOWN
MAINLINE
ORIGINAL
BUILT-IN
CONTROLLER
DOOR MOTOR LOCK
(Inside of the front door)
1.) For Factory installed central door lock system
2.)Directlyconnectto2wire Actuator
3.) A built-inCentraldoorlockwithelectriclockswitch( like: CHRYSLER.. )
2 WIRE ACTUATOR
+ 12V
(-)GND
ELECTRIC
MOTOR
MOTOR LOCK
INSIDE THE
FRONT DOOR
+ 12V
UP
DOWN
Central door lock wiring
Centraldoorlockwiring
Centraldoorlockwiring
LOCKMOTOR
UNLOCKMOTOR
Green/black
Green
Green/red
Blue/black
Blue
Blue/red
4.) For vacuum type central door lock system ( like : Mercedes Benz , AUDI.. )
ELECTRIC
MOTOR
AIR COMPRESSOR
+ 12V
DOWN
UP
Note: Door lock active time for 4 secs.
Centraldoorlockwiring