Changing of the PIN code to turn off the system
This system provide 2 digit PIN code, each digit code can be programme from 1 to 9 , and manufacturer code is ( 1.2).
To program your new PIN code as follows:
1. Enter the system into the Valet mode .
2. Turn ignition switch from ON to OFF .
3. Within 10 seconds, press the Valet switch on-off for 5 times.
4. Siren/Horn will provide 2 long chirp to confirm the system is in PIN code setting mode.
<< Suppose that you want set new PIN code is 3.8 >>
5. To programme the 1st PIN code by press the Valet button the number of times corresponding to the 1st digit of your
PIN code. Press 3 times of the Valet button, (each time the Valet button is pressing, the chirp sound will be given) .
6. Waiting 1sec. until the LED flash once. To confirm the 1st digit has been inserted.
7. To programme the 2nd PIN code by press the Valet button the number of times corresponding to the 2nd digit of
your PIN code. Press 8 times of the Valet button, (each time the Valet button is pressing, the chirp sound will be
given) .
8. Waiting 1sec. until the LED flash once. To confirm the2nd digit has been inserted.
9. It will give 2 chirp sound and then LED will notify the 2 digit PIN code, by 3 flashes - pause - 8 flashes.
10. To Exit the mode, turn ignition to ON , or within 20sec. It will exit and in Valet mode.
Note:
Please notice that the time between your actions shall be less than 20 sec; otherwise the system will automatically
Emergency disarming of the system using the PIN code:
To use the PIN coded disarming mode . Please contact your installation technician or see Functions to be
programmed section and the Installation manual. If the system triggering
on, you can use the manufacturer code (1.2) or to provide the maximum arming of your car you can program your own
PIN code for disarming at any time. The code comprises two digit; each digit can vary from 1 to 9.
To disarm the system using the PIN code
1. Open the door with the key (the system will be triggered and the parking lights will go on and so on).
2. Turn on the ignition .
3. Press the Valet button the number of times which is in accordance with the first digit of your PIN code (the
manufacturer setting is 1 time). Each time the Valet button is pressing, the LED will activated .
4. Waiting 1sec. until the LED flash once.
5. Press the Valet button the number of times which is in accordance with the second digit of your PIN code (the
manufacturer setting is 2 time). Each time the Valet button is pressing, the LED will activated .
6. Waiting 1sec. until the LED flash once.
7. System will automatically disarmed and into the Valet mode.
Note:
If you enter the wrong code , turn off the ignition then start from step #2.
To Next Page
Loading...
