User Manual 200 kVA-1200 kVA UPS 1 Safety Information
4
1 Safety Information
1. 1 General Information
Before installing and using this product, please read Safety Information carefully to ensure correct and safe
installation and use, and keep this manual properly.
UPS must be installed, adjusted and maintained by an engineer authorized by the manufacturer or its agent,
otherwise it is possible to endanger personal safety and cause equipment failure. The damage to UPS caused
hereon will excluded from the warranty scope.
In no event is it allowed to dismantle or change the structure or components of the equipment without the
manufacturer's permission, otherwise the damage to UPS caused hereon will excluded from the warranty
scope.
Local laws and regulations should be observed during use of the equipment. The safety instructions provided
herein are only supplementary to local safety codes.
Due to product version upgrade or other reasons, the contents of this document will be updated from time to
time. Unless otherwise agreed, this document serves only as a use guidance, and all statements, information,
images and recommendations contained in this document do not constitute any express or implied warranty.
1. 2 UPS Safety
Before installing the equipment, wear insulating protective clothing and insulating appliances, and remove
easily conductive objects such as jewelry and watches to avoid electric shock or burns.
The service environment has a certain impact on the service life and reliability of UPS, and the use and
storage of equipment must follow the requirements set in the manual.
Avoid using the equipment in the environment with direct sunlight, rain or dust containing electric charge.
During storage of UPS, keep a safe distance around it to ensure ventilation. Do not block the air vent while
the system is running.
Do not allow liquids or other foreign objects into the UPS cabinet or case.
Before using UPS, check whether the local power characteristics are consistent with the information on the
product nameplate.
UPS is a large leakage current equipment, and it is not recommended to conFig. an air switch with leakage
protection function.
Before wiring UPS, please further confirm whether the mains input power supply, bypass power supply,
battery switch and mains power distribution switch are disconnected.
When it is required to move or rewire UPS, AC input power, battery and other input must be disconnected,
and the corresponding operation should be carried out after UPS is fully powered down (more than 9min),
otherwise there may still be power on the port and inside of the device, which may cause risk of electric
shock.
Before powering on, please make sure the equipment is properly grounded, and check the connection and
battery polarity to make sure they are correct. In order to ensure personal safety and the normal use of UPS,
UPS should be reliably grounded before use.
UPS can be used for resistance-capacitance (such as computer), resistance-resistance and micro-inductive
load, and not for half-wave rectifying load.
When the equipment is cleaned, please wipe it with dry articles. Do not use water to clean the internal and
external electrical components of the cabinet under any circumstances.
To Next Page
