To Next PageTo Next Page
Need help?Do you have a question about the Eastron SDM320-C and is the answer not in the manual?
General| Base Current (Ib) | 5A |
|---|---|
| Accuracy | Class 1 |
| Impulse Voltage | 6kV |
| Display | LCD |
| Communication | RS485 |
| Protocol | Modbus RTU |
| Mounting | DIN Rail |
| Operating Temperature | -25°C to +55°C |
| Storage Temperature | -40°C to +70°C |
| Protection Degree | IP51 |
| Rated Voltage (Un) | 230V |
| Starting Current | 0.004A |
| Power Consumption | <2VA |
| Frequency | 50/60Hz |
| Overcurrent Withstand | 10Imax |
Details the measurable parameters and configurable settings of the unit.
Provides detailed technical specifications for electrical and communication features.
Explains how to operate the buttons for data checking and set-up mode.
Describes how to cycle through measured values using the scroll button.
To enter set-up mode, it asks for password confirmation.
Explains how to set and confirm the Modbus communication address.
Instructions for configuring the communication baud rate for RS485.
Guidance on setting the parity bit for RS485 communication.
How to set the pulse constant for energy pulse output.
Configuration options for pulse output units: kWh or kVArh.
Setting the integration period for maximum demand measurement.
Configuration for automatic display scrolling interval.
Setting the duration for the display backlight.
This meter provides a function to set a new password.
Check alarm correlation, object, value, and relay status.
Configure relay status (open/close) during alarm events.
