Why is my Eaton UPS operating on battery when AC power is available?
Your Eaton UPS might be operating on battery power because the circuit breaker located under the UPS has been tripped due to an overload. To resolve this, disconnect some equipment to reduce the load and then reset the circuit breaker by pressing the button.
Why is the red LED flashing on my Eaton 3S 700 UPS?
If the red LED is flashing on your Eaton UPS, it indicates that the battery has reached the end of its service life. You will need to have the battery replaced.
How to fix Eaton UPS filtered outlets not working?
If the filtered outlets on your Eaton UPS are not working, it could be due to two reasons: either the wall outlet isn't supplying power, or the circuit breaker located under the UPS has been tripped by an overload. First, ensure the wall outlet has power. If it does, disconnect some equipment to reduce the load, and then reset the circuit breaker by pressing the button.
What to do if green button 8 flashes and alarm beeps continuously on Eaton 3S 700?
If the green button on your Eaton UPS flashes frequently and the alarm beeps continuously, it means the battery backup outlets are overloaded. To fix this, disconnect some of the equipment connected to the battery backup outlets.
Why does the green button 8 flash and the alarm beep on my Eaton 3S 700?
The green button flashing and the alarm beeping on your Eaton UPS indicates that it's frequently running on battery power due to a poor AC power source. Consider having your electrical installation checked by a professional or try using a different wall outlet.
What to do if Eaton UPS doesn't supply power to connected devices during AC power failure?
If your Eaton UPS isn't supplying power to connected devices when AC power fails, ensure that the devices are connected to the battery backup outlets.
What does it mean when the red LED 7 is on and the alarm beeps every 30 seconds on my Eaton 3S 700?
A red LED and an alarm beeping every 30 seconds on your Eaton UPS indicate a fault. The battery backup outlets are no longer supplied.
Why is my telephone line disturbed when using Eaton 3S 700 UPS?
If your telephone line is disturbed or modem access isn't possible when using your Eaton UPS, it means surge protection on the telephone line is no longer provided. Disconnect the telephone line from the wall outlet.
General| Power Rating | 700 VA / 420 W |
|---|---|
| Nominal Input Voltage | 230V |
| Output Voltage | 230V |
| USB Port | Yes |
| Typical Recharge Time | 8 hours |
| Surge Protection | Yes |
| Audible Alarm | Yes |
| Waveform Type | Stepped approximation to a sinewave |
| Communication Interface | USB |
| Battery Type | Sealed Lead Acid |
| Typical Backup Time at Full Load | 5 minutes |
| Operating Temperature | 0° to 40°C |
| Storage Temperature | -15° to 45°C |
| Humidity | 0% to 95% (non-condensing) |
| Output Connections | (4) IEC-320 C13 |
Read safety instructions before installing the Eaton 3S and follow manual instructions.
Connect the UPS to AC power and plug critical equipment into battery backup outlets.
Describes battery charging, switching on the UPS, and power outage behavior.
Guidelines on battery lifespan reduction and safe disposal procedures.
To Next Page
