Eaton 9372-FB-P Series Firmware Update

MTL GECMA RT – KVM Firmware Update EN 11
Attention: Do not switch off the terminal, the SATU nor the computer during the update! Do
not press any buttons during this time and do not operate the mouse!
Notice: Both units (remote and local) receive the update simultaneously.
 After a successful update the following menu will be displayed at the end of the update
process:
Figure 8
 A reboot of the SATUs is initiated.
At this point, we recommend disconnecting the power supply from the transmitter and the
remote terminal for about 60 seconds. It may also be helpful to temporarily remove the DVI
and USB cables to ensure that the memory is completely reinitialized.

Eaton 9372-FB-P Series Specifications

General

Brand	Eaton
Model	9372-FB-P Series
Category	Lighting Equipment
Language	English