COMMUNICATION FEATURES
Eaton 9910 UPS and EBM User's Guide S P-164000005 Rev 2
38
3. Run the Software Wizard, which guides you through the installation
process.
For more information about configuring and operating the software, see
the online help.
Communication Ports
The UPS has a USB port and an RS-232 port that you can use for UPS
monitoring, control, and firmware updates. After communication is
established between the UPS and a computer, you can use the UPS
Manager software to exchange data between the UPS and the
computer. The software polls the UPS for detailed information about the
status of the power environment. If a power emergency occurs, the
software initiates the saving of all data and an orderly shutdown of the
devices that are connected to the UPS.
For the communication port locations, see “UPS Rear Panels” on
page 2.
NOTE Only one of the communication ports can be active at one time. The USB port has
priority over the RS-232 port.
USB Port
The UPS can communicate with a USB-compliant computer through the
UPS Manager software, which is compatible with a human interface
device (HID). To establish communication between the UPS and a
computer, connect a USB cable (not supplied) to the USB port on the
UPS. Connect the other end of the USB cable to a USB port on a
computer.
To Next Page
Loading...
