Eaton 9910 - Configuring Automatic Battery Tests; Configuring Automatic Restart

OPERATION
Eaton 9910 UPS and EBM User's Guide S P-164000005 Rev 2
35
Configuring Automatic Battery Tests
To configure the automatic battery tests:
1. From the main menu, press the down (
B
) button to scroll to the
Configuration menu, and press the OK button.
2. Press the down (
B
) button to scroll to Automatic Battery Tests, and
press the OK button.
3. Press the down (
B
) button to select whether to enable or disable
the automatic battery test.
4. Press the OK button for 1 second to confirm.
Configuring Automatic Restart
The UPS automatically restarts if the utility power returns after the
output was shut off because of depleted batteries, a shutdown input
signal, or an automatic shutdown command.
You can set the load segment for the amount of time to delay the restart
when utility power returns by using the Automatic Start Delay setting (see
Table 4 on page 26).