Eaton EX RT 11 - Display and Control Panel Features; Optional Accessories and Modules

86-86000-01 B01 - Page 7
STEP 3 Rack Configuration (continued)
Install I/O Box Bracket to keep the I/O Box stationary while
hot swapping the power module.
1. Secure small bracket to larger
bracket from the underside.
2. Secure large bracket to rails at
the rear of module with four nuts.
1
2
OFF
O
2
3
3
3. Secure attached brackets
to the I/O Box with four screws.
C. Installation of Power Module I/O Box Bracket (this step only applies to power module)
2