MN04002001E
4
March 2006
Step 2 — Keypad Operation (Continued)
Keypad Operators, continued
Explanation of Display Messages
LEFT Arrow
•
navigation button, movement to left
•
in display mode, enter parameter group mode
•
in parameter edit mode, exits mode, backs up one step
•
cancels edited parameter (exit from a parameter edit mode)
RIGHT Arrow
•
navigation button, movement to right
•
enter parameter group mode
•
enter parameter mode from group mode
UP and DOWN Arrows
•
move either up or down the group list in order to select the desired
group menu.
•
move either up or down the parameter list in order to select the
desired parameter in the group.
•
increasing/decreasing of reference value on the keyboard (when
selected).
SPEED POT
•
increase/decrease reference value on the keypad (when selected)
Displayed
Message Descriptions
The AC drive Input Frequency Reference.
The Actual Operation Frequency at the output terminals T1, T2 and T3.
The output current present at the output terminals T1, T2 and T3.
The value of the user defined units.
The output voltage present at the output terminals T1, T2 and T3.
The temperature of the unit.
The AC drive forward run status.
The AC drive reverse run status.
Parameter group selection.
The specific parameter selection.
“End” displays for approximately 1 second if input has been accepted.
After a parameter value has been set, the new value is automatically
stored in memory.
“Err” displays, if the input is invalid.
F
H
A
U
MN04002001E.fm Page 4 Thursday, April 13, 2006 11:11 AM
To Next Page
Loading...
