MN04002001E
5
March 2006
Step 3 — Parameter Navigation
This page contains the descriptions of the MVX9000 parameters. Parameters are
addressed and changed via the keypad for the MVX9000. For more information
on keypad operation, see Keypad Operation located in Chapter 2 of the manual.
Viewing and Changing Parameter Settings
Page Groups
Parameters are grouped in a page
arrangement. Each page will contain a
list of the parameters associated with
that group. Move into the page groups
from the display menu by using the right
arrow key.
Parameter Groups
Select the desired parameter group by
using the up and down keys. Once the
parameter group is located, use the right
arrow key to enter the group. Use the up
and down keys to scroll the parameters
on that page.
Parameters
Once the parameter has been located,
use the right arrow key to view the
parameter setting.
Programming Mode
Use the ENTER key to enter the
programming mode. The displayed
parameter will flash indicating the
parameter can be changed.
Parameter Changes
Use the up and down keys to change the
parameter setting. Press ENTER to enter
the new parameter setting.
If the parameter change is successful, the
keypad will display the end (End)
message and return to the parameter number display. If the parameter change is
unsuccessful the keypad will display an error (Err) message, the parameter will
not be changed, and the parameter number will again be displayed.
Note: Some parameters cannot be changed while the unit is the RUN/START
mode.
To Exit Programming
Mode
Pressing left arrow backs
out of Parameter Mode
and returns you to
Display Mode.
USER
AMPS
Hz
Display
20
30
40
40.01
40.02
40.03
40.04
40.05
20
30
40
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
H
F
STOP
RUN REVFWD
U
A
Successful
Parameter Change
Unsuccessful
Parameter Change
40
20
30
Parameter Parameter
Number
Parameter Groups Display
H
F
STOP
RUN REVFWD
U
A
MN04002001E.fm Page 5 Thursday, April 13, 2006 11:11 AM
To Next Page
Loading...
