Eaton MVX9000 Series - Page 9

MN04002001E
8
March 2006
Step 4 — Parameter Groups & Default Values (Continued)
30 — INPUTS (Continued)
40 — OUTPUTS
Modbus Groups Description Range Default
User
Settings
010BH
010CH
010DH
010EH
30.12
30.13
30.14
30.15
Digital Input Terminal
(DI3)
Digital Input Terminal
(DI4)
Digital Input Terminal
(DI5)
Digital Input Terminal
(DI6)
29: Output Shut Off (NO) 05
06
07
03
30: Output Shut Off (NC)
31: Auto Location – Operation &
Frequency by First source (P50.01 &
P50.02)
32: Hand Location – Operation &
Frequency by Second source
(P50.57 & P50.60)
33: LOC – Operation & Frequency by
Second source (P50.57 & P50.60)
010FH 30.16 Final Count Value 00 to 9999 00
0110H 30.17 Intermediate Count
Value
00 to 9999 00
0111H 30.18 1st Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0112H 30.19 2nd Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0113H 30.20 3rd Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0114H 30.21 4th Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0115H 30.22 5th Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0116H 30.23 6th Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0117H 30.24 7th Preset Speed 0.0 to 400.0 Hz (100.0%) 0.0
0118H 30.25 Display Hz or % 00: Frequency (Hz) 00
01: Percentage (%)
02: User Definition by 0.000 – max.
unit
0119H 30.26 Extension Input DI7 same 30.12 to 30.15 00
011AH 30.27 Extension Input DI8 same 30.12 to 30.15 00
011BH 30.28 User Definition
Display Frequency
Max Unit
0.000 – 1.000 1.000
Modbus Groups Description Range Default
User
Settings
0200H 40.01 Analog Output Signal 00: Frequency Hz 00
01: Current A
02: Feedback signal 0 – 100
03: Output Power 0 – 100%
0201H 40.02 Analog Output Gain 00 to 200% 100
0202H
0203H
40.03
40.04
Digital Output
Terminal
(DO1-DCM)
Relay Output
Terminal
(RO1, RO2, RO3)
00: Not used 02
03
01: Ready
02: Inverter Output is active
03: Inverter Fault
04: Warning (PID feedback loss,
communication fault)
05: At speed
06: Zero speed
07: Above Desired Frequency (40.05)
08: Below Desired Frequency (40.05)
09: PID supervision
10: Over Voltage Warning
11: Over Heat Warning
12: Over Current Stall Warning
13: Over Voltage Stall Warning
14: Low voltage
15: PLC Program running
16: PLC Program Step completed
17: PLC Program completed
18: PLC Operation paused
MN04002001E.fm Page 8 Thursday, April 13, 2006 11:11 AM