NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
136
11/04 MN01219002Z-EN
Circuit-breaker locally set parameters object
This object contains the parameters set locally in the
electronic control unit.
This object is a read only object. It can be accessed by class 1
and/or a class 2 DPV1 master.
Intended usage
Use this object in order to get informed about the locally set
parameters
• Limitation value and delay time of the overload release,
• Limitation value and delay time of the short-time delayed
short-circuit release,
• Limitation value of the non-delayed short-circuit release,
I
sd
Octet 6 Parameters used: I
sd
1)
a table 24
T
sd
Octet 7 Parameters used: T
sd
1)
a table 25
I
dn
Octet 8 Parameters used: I
dn
1)
a table 22
T
vdn
Octet 9 Parameters used: T
vdn
1)
a table 25
1) Prerequisite: Parameter is supported by the connected circuit-breaker, otherwise “Not
used”.
h
The Table 21 to Table 25 can be found with Section
“Circuit-breaker diagnosis data records object 1 to 10”,
Page 118.
Variable access
(example)
Data position Meaning
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
