NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
170
11/04 MN01219002Z-EN
Table 47: Address location and meaning of the object data
content
DMI outputs object
This object contains the current states of the outputs Q0 to
Q5 of the DMI.
This object is a read only object. It can be accessed by class 1
and/or a class 2 DPV1 master.
Intended usage
Use this object in order to obtain information concerning the
state of the outputs of the DMI.
Variable access
(example)
Data position Meaning
Octet 1
DMI_Inputs[1] Bit 0 State I0
DMI_Inputs[2] Bit 1 State I1
DMI_Inputs[3] Bit 2 State I2
DMI_Inputs[4] Bit 3 State I3
DMI_Inputs[5] Bit 4 State I4
DMI_Inputs[6] Bit 5 State I5
Bit 6 and Bit 7 Not used
h
A set bit corresponds to the “ON” state and a bit which is
not set corresponds to the “OFF” state.
h
With a parameterized motor-starter function, inputs I1
and I3 indicate the current state of the motor control
(a section “Format of the data inputs”, Page 86.
h
You can read the state of all outputs of the DMI with this
object, regardless of if they have been parameterized for
“bus access”.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
