Eaton NZM2 - DMI Bus Outputs Object Data Content

NZM-XDMI-DPV1
(PROFIBUS-DPV1 Interface for
DMI)
174
11/04 MN01219002Z-EN
Table 49: Address location and meaning of the object data
content
DMI device identification object
This object contains the device identification of the
connected DMI (ASCII string).
This object is a read only object. It can be accessed by class 1
and/or a class 2 DPV1 master.
Variable access
(example)
Data position Meaning
Octet 1
DMI_Bus_outputs[1] Bit 0 New state Q0
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
DMI_Bus_outputs[2]
Bit 1 New state Q1
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
DMI_Bus_outputs[3]
Bit 2 New state Q2
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
DMI_Bus_outputs[4] Bit 3 New state Q3
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
DMI_Bus_outputs[5]
Bit 4 New state Q4
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
DMI_Bus_outputs[6]
Bit 5 New state Q5
(only if switching signal has been parameterized
for bus access and there is no cyclic data transfer)
Bit 6 and Bit 7 Not used
h
A set bit corresponds to the “ON” state and a bit which is
not set corresponds to the “OFF” state.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com