5
2 Safety warnings
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions that should be followed during installation of the Field
Installed UPM (FI-UPM). Read all instructions before operating the equipment and save this manual for
future reference.
The FI-UPM cabinet is designed for industrial or computer room applications, and contains safety
shields behind the panel. However, the FI-UPM is a sophisticated power system and should be handled
with appropriate care.
The FI-UPM contains LETHAL VOLTAGES. All repairs and service should be performed by
AUTHORIZED SERVICE PERSONNEL ONLY. There are NO USER SERVICEABLE PARTS inside the
FI-UPM.
• The UPS system contains its own energy source (batteries). The output terminals may carry
live voltage even when the UPS is disconnected from an AC source.
• To reduce the risk of fire or electric shock, install this UPS and FI-UPM in a temperature and
humidity controlled, indoor environment, free of conductive contaminants. Ambient
temperature must not exceed 40°C. Do not operate near water or excessive humidity (95%
maximum). The system is not intended for outdoor use.
• Ensure all power is disconnected before performing installation or service.
• ELECTRIC ENERGY HAZARD. Do not attempt to alter any battery wiring or connectors.
Attempting to alter wiring can cause injury.
• Keep the FI-UPM front panel installed to ensure proper cooling airflow and to protect
personnel from dangerous voltages inside the unit.
• Do not install or operate the UPS system or FI-UPM close to gas or electric heat sources.
• The operating environment should be maintained within the parameters stated in this
manual.
• Keep surroundings uncluttered, clean, and free from excess moisture.
• Observe all DANGER, CAUTION, and WARNING notices affixed to the inside and outside of
the equipment.
To Next Page
Loading...
