INTRODUCTION
Eaton 9355 UPS (10/15 kVA) User's Guide S 164201594 Rev D www.eaton.com/powerquality
3
The following options for the Eaton 9355 UPS UPS are available:
S Remote Monitor Panel
The optional Remote Monitor Panel (RMP) provides monitoring of the
operational status and alarm condition of the UPS from virtually any
location within the facility. You can install multiple RMPs at remote
locations to increase your monitoring capabilities.
S Power Distribution Module
The optional Power Distribution Module (PDM) comes equipped with
several different types of output receptacles.
S Parallel Tie Cabinet
An optional parallel system with up to four UPSs can be installed to
provide a parallel capacity and/or redundant system. This load sharing
system provides more capacity than a single UPS and can provide
backup, depending on the load and configuration. In addition, when
one UPS is taken out of service for maintenance or is not operating
properly, a redundant UPS continues to supply uninterrupted power
to the critical load. A parallel Powerware Hot Sync Controller Area
Network Bridge Card provides connectivity for system metering and
operational mode control. The parallel system consists of two to four
UPSs, each with a parallel CAN Bridge Card, and a parallel tie cabinet.
Refer to the Eaton 9355 Parallel UPS (10/15 kVA) User's Guide for
more information.
S Wall-Mounted Bypass Switch
The optional wall-mounted bypass switch is used to bypass the UPS
during maintenance or servicing, providing wrap-around bypass for
UPS service without shutting down the load.
S Input Isolation Transformer
The optional input isolation transformer is located at the bottom of a
3-high UPS model. The isolation transformer allows operation from a
480V or 600V 60-Hz source.
S Seismic Kit
The optional seismic kit secures the UPS and optional EBMs for
Zone 4 seismic installations.
To Next Page
Loading...
Need help?
General