VERSION 1 WALL-MOUNTED BYPASS SWITCH
Eaton 9355 UPS (10/15 kVA) User's Guide S 164201594 Rev D www.eaton.com/powerquality
33
10. Verify that the UPS battery circuit breaker is in the OFF position
(see Figure 21).
11. Remove the UPS wiring access cover and one of the conduit
landing plates and retain.
12. Punch two holes in the conduit landing plate for the input and
output conduit using a Greenlee punch or similar device.
Battery Circuit Breaker
UPS Wiring
Access Cover
Conduit Landing Plates
Figure 21. UPS Rear View (3-High Shown)
To Next Page
Loading...
