EXTENDED BATTERY MODULE INSTALLATION
Eaton 9355 UPS (10/15 kVA) User's Guide S 164201594 Rev D www.eaton.com/powerquality
61
8. Remove the top front covers of all cabinets.
9. Install the remaining ground straps between each cabinet (see
Figure 45).
10. Reinstall the top front covers removed in Step 8.
Hang the top edge of the cover on the cabinet first, then lower the
bottom edge and snap into place.
11. Continue to one of the following sections:
S “Communication” on page 63 to install UPS communication
options, such as X-Slot cards or remote emergency power-off.
S “Operation” on page 81 to start up the UPS.
NOTE After UPS startup, ensure maximum battery runtime by configuring the UPS for the
correct number of EBMs (see page 91).
Front Ground Strap
Figure 45. Front Ground Strap Installation (2-High Cabinets Shown)
To Next Page
Loading...
