COMMUNICATION
Eaton 9355 UPS (10/15 kVA) User's Guide S 164201594 Rev D www.eaton.com/powerquality
66
4. Route the cable(s) to the approximate location of the cover access
holes.
5. Connect the cables to the appropriate location.
See “Communication Options” on page 67 or “Control Terminals”
on page 76 for detailed information.
6. Reinstall the front covers, starting with the bottom cabinet (see
Figure 50).
Hang the top edge of the cover on the cabinet first, then lower the
bottom edge and snap into place. Verify that the cables fit in the
access holes in the covers.
Figure 50. Reinstalling the Front Covers
7. Continue to “Operation” on page 81 to start up the UPS.
NOTE After UPS startup, ensure maximum battery runtime by configuring the UPS for the
correct number of EBMs (see page 91).
To Next Page
Loading...
