Eaton Powerware Series Quick Start Instructions

Figure 17. Verify Configuration Settings
Figure 18. Verify Configuration Settings
Figure 19. Verify Configuration Settings
Figure 20. Clear Communication Message
Eaton
®
ConnectUPSt Web/SNMP Card (X and BD Models) Quick Start Instructions 164950185 Rev B
www.eaton.com/powerquality
9
10. Select your preferred method of shutting down your system
(see Figure 17). The default selection is recommended.
Select
Next.
11. The Event and Logging Options dialog opens (see Figure 18).
Select
Next.
12. Verify the configuration settings are correct and select Finish
(see Figure 19).
13. A pop-up message indicates that communication with the
card is established (see Figure 20). Select
Clear to
acknowledge the message.
14. Repeat Steps 1 through 13 on all computers powered by the
corresponding UPS using this specific card.
NetWatch installation and configuration is now complete.

Eaton Powerware Series Specifications

General

Brand	Eaton
Model	Powerware Series
Category	UPS
Language	English