Eaton PowerXL DM1-113D0NB-S20S - Page 37

27
Chapter 4—Mechanical installation
POWERXL SERIES VFDS MN040060EN—September 2020 www.eaton.com
Step 2
Remove the two screws ③, NEMA 1 kit front cover ①, and
terminal cover ② (See A).
Insert the hooks on back surface of NEMA 1 kit main frame
⑦ into the corresponding rectangular openings on drive
bottom surface, then use two screws ⑯ to fix the conduit
box to the metal grounding plate of drive (See B).
Step 3
Remove the two screws ④ and NEMA 1 kit bottom plate ⑤
(See A).
Mount the conduit fittings ⑧ and ⑨ on NEMA 1 kit bottom
plate ⑤ (See B).
A
B
Hooks
NEMA 1 kit front cover ①
Terminal cover ②
Screws ③
NEMA 1 kit Main frame ⑦
Screws ⑯
A
B
Conduit fittings for power wires ⑧
Conduit fittings for control wires ⑨
Screws ④
NEMA1 kit bottom plate ⑤