Eaton PowerXL DM1 Series - Page 143

133
Chapter 6 - Pump control application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 50. Serial communication (Cont.).
P11.5.4
Board status
ID 2609
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Description:
Status of the board.
B0-DCOM communication fault.
B1-Board HW fault
B2-IO1 24 volt overload fault.
B3-Profibus communication fault.
B4-fieldbus fault.
P11.5.5
Firmware version
ID 2610
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Description:
This parameter provides the firmware version of the SWD.
P11.5.6
Protocol status
ID 2612
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Not configured;
1 = Operational; or
2 = Diagnostics.
Description:
This parameter specifies the protocol status for SWD card.
P11.6 - Bluetooth.
P11.6 .1
Bluetooth enabled
ID 1895
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Disabled; or
1 = Enabled.
Description:
Bluetooth enabled.
P11.6 .2
b
Bluetooth broadcast mode
ID 2920
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Off; or
1 = On.
Description:
Bluetooth broadcast mode.
P11.6 .3
Bluetooth pairing reset
ID 2935
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = Not reset; or
1 = Reset.
Description:
Bluetooth pairing reset.
a
Parameter value can only be changed after the drive has stopped.
b
Parameter value will be set to be default when changing macros.
Table 51. Ethernet communication (*DM1 Pro) (Cont.).
P12.1 - Basic settings (*DM1 Pro).
P12.1.1
a
IP address mode
ID 1500
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Static IP; or
1 = DHCP with AutoIP.
Description:
This parameter defined the IP address configuration mode for EIP/modbus TCP.
.