Eaton PowerXL DM1 Series - Page 225

215
Chapter 7- Multi-purpose application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 68. Fieldbus (FB) status (Cont.).
P10.1.4
b
FB process data input 4 selection
ID 2536
Minimum value:
0
Maximum value:
12,464
Default value:
103
Description:
With the fieldbus data output selections, parameter/monitor IDs can be assigned to these registers and then read over the desired
fieldbus network word for process data. Any drive parameter with an ID can be read over these values.
Default values for process data in:
Process data IN1 = NULL = ID 0;
Process data IN2 = FB PI Set Point1= ID 2542;
Process data IN3 = FB PI Feedback1= ID 2550;
Process data IN4 = Acceleration time 1= ID 103;
Process data IN5 = Deceleration time 1= ID 104;
Process data IN6 = Current limit= ID 107;
Process data IN7 = NULL= ID 0; or
Process data IN8 = NULL= ID 0.
P10.1.5
b
FB process data input 5 selection
ID 2537
Minimum value:
0
Maximum value:
12,464
Default value:
104
Description:
With the fieldbus data output selections, parameter/monitor IDs can be assigned to these registers and then read over the desired
fieldbus network word for process data. Any drive parameter with an ID can be read over these values.
Default values for process data in:
Process data IN1 = NULL = ID 0;
Process data IN2 = FB PI Set Point1= ID 2542;
Process data IN3 = FB PI Feedback1= ID 2550;
Process data IN4 = Acceleration time 1= ID 103;
Process data IN5 = Deceleration time 1= ID 104;
Process data IN6 = Current limit= ID 107;
Process data IN7 = NULL= ID 0; or
Process data IN8 = NULL= ID 0.
P10.1.6
b
FB process data input 6 selection
ID 2538
Minimum value:
0
Maximum value:
12,464
Default value:
107
Description:
With the fieldbus data output selections, parameter/monitor IDs can be assigned to these registers and then read over the desired
fieldbus network word for process data. Any drive parameter with an ID can be read over these values.
Default values for process data in:
Process data IN1 = NULL = ID 0;
Process data IN2 = FB PI Set Point1= ID 2542;
Process data IN3 = FB PI Feedback1= ID 2550;
Process data IN4 = Acceleration time 1= ID 103;
Process data IN5 = Deceleration time 1= ID 104;
Process data IN6 = Current limit= ID 107;
Process data IN7 = NULL= ID 0; or
Process data IN8 = NULL= ID 0.
P10.1.7
b
FB process data input 7 selection
ID 2539
Minimum value:
0
Maximum value:
12,464
Default value:
0
Description:
With the fieldbus data output selections, parameter/monitor IDs can be assigned to these registers and then read over the desired
fieldbus network word for process data. Any drive parameter with an ID can be read over these values.
Default values for process data in:
Process data IN1 = NULL = ID 0;
Process data IN2 = FB PI Set Point1= ID 2542;
Process data IN3 = FB PI Feedback1= ID 2550;
Process data IN4 = Acceleration time 1= ID 103;
Process data IN5 = Deceleration time 1= ID 104;
Process data IN6 = Current limit= ID 107;
Process data IN7 = NULL= ID 0; or
Process data IN8 = NULL= ID 0.