Eaton PowerXL DM1 Series - Page 239

229
Chapter 7- Multi-purpose application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Table 69. Serial communication (Cont.).
P11.6 .3
Bluetooth pairing reset
ID 2935
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Options:
0 = Not reset; or
1 = Reset.
Description:
Bluetooth pairing reset.
a
Parameter value can only be changed after the drive has stopped.
b
Parameter value will be set to be default when changing macros.
Table 70. Ethernet communication (*DM1 Pro) (Cont.).
P12.1 - Basic settings (*DM1 Pro).
P12.1.1
a
IP address mode
ID 1500
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
0
Options:
0 = Static IP; or
1 = DHCP with AutoIP.
Description:
This parameter defined the IP address configuration mode for EIP/modbus TCP.
P12.1. 2
Active IP address
ID 1507
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Description:
Reads the current active IP address.
P12.1.3
Active subnet mask
ID 1509
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Description:
Reads the current active subnet mask.
P12.1.4
Active default gateway
ID 1511
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Description:
Reads the current active default gateway.
P12.1.5
MAC address
ID 1513
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
N.A.
Description:
Reads the current MAC address.
P12.1.6
a
Static IP address
ID 1501
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.254
Description:
Defines the static IP address.
P12.1.7
a
Static subnet mask
ID 1503
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
255.255.255.0
Description:
Defines the static subnet mask.
P12.1.8
a
Static default gateway
ID 1505
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.1
Description:
Defines the static default gateway.
P12.1.9
Ethernet communication timeout
ID 611
Minimum value:
0 ms
Maximum value:
60,000 ms
Default value:
10,000 ms
Description:
Selects the time it waits before a communication fault occurs over ethernet.
P12.2 - Trusted IP filter (DM1 PRO only).
P12.2.1
Trusted IP white list
ID 68
Minimum value:
N.A.
Maximum value:
N.A.
Default value:
192.168.1.255
Description:
Defines the IP addresses in the white list. A setting of 192.168.1.255 enables all connections on the local subnet.
.