Eaton PowerXL DM1 Series - Page 61

51
Chapter 5 - Fan control application
POWERXL DM1 SERIES VARIABLE FREQUENCY DRIVES MN040049EN—September 2021 www.eaton.com
Fan application - parameters list
On the next pages you will find the lists of parameters
within the respective parameter groups. Each parameter
section within the table lists:
•
Parameter code (location indication on the keypad;
shows the operator the present parameter number);.
•
Parameter name;
•
ID (number of the parameter);
and where applicable:
•
Minimum value and units;
•
Maximum value and units;
•
Default value and units;
•
Options (when available); and
•
Description of the parameter.
Table 22. Monitor (Cont.).
M1 - standard.
M1.1
Output frequency
ID 1
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Output frequency (Hz).
M1.2
Frequency reference
ID 24
Minimum value:
Hz
Maximum value:
Hz
Default value:
Hz
Description:
Reference frequency (Hz).
M1.3
Motor speed
ID 2
Minimum value:
rpm
Maximum value:
rpm
Default value:
rpm
Description:
Motor output speed (rpm).
M1.4
Motor current
ID 3
Minimum value:
A
Maximum value:
A
Default value:
A
Description:
Motor output current RMS (Amps).
M1.5
Motor torque
ID 4
Minimum value:
%
Maximum value:
%
Default value:
%
Description:
Percent motor torque calculated from nameplate values and measured motor current (%).
M1.6
Motor power
ID 5
Minimum value:
%
Maximum value:
%
Default value:
%
Description:
Percent motor power calculated from nameplate values and measured motor current (%).
M1.7
Motor voltage
ID 6
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
Output ac motor voltage (Vac).
M1.8
DC-link voltage
ID 7
Minimum value:
V
Maximum value:
V
Default value:
V
Description:
DC bus voltage (Vdc).
.