Eaton Tripp Lite SmartOnline Series - Extended Battery Pack Rackmount Connections

12 Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01
Figure 10. External Battery Pack Rack Installation
2
1
3
2
4
22..44..22 EExxtteennddeedd BBaatttteerryy PPaacckk RRaacckkmmoouunntt CCoonnnneeccttiioonnss
NOTE A small amount of arcing may occur when connecting an external battery pack to the
UPS. This is normal and will not harm personnel.
To connect the external battery packs to the UPS:
1. Insert the external battery pack cable into the UPS battery connector quickly and firmly.
2. Plug the external battery pack power cable(s) into the external battery connector(s) and repeat until all
external battery packs are connected. Up to 4 external battery packs may be connected to the UPS. See
Figure 11 .
SmartOnline External Battery Pack Installation