Eaton Tripp Lite SmartOnline Series - 3.6 Communication Ports

Tripp Lite by Eaton SmartOnline Series User Guide 614-21325—Rev 01 23
Table 7. User Settings (Continued)
Main Menu Screen Submenu Submenu Menu Function
OUTPUT DB9–7 UPS OK* (Default) [ON
BATTERY] [LOW BATTERY]
[BATTERY FAULT] [BYPASS]
[UPS OK] [LOAD PROTECTED]
[LOAD POWERED] [GENERAL
ALARM] [BAT CHARGING]
[OVLD PREALARM] [BAT
DISCONN]
Sets events or fault that will
actuate Output signal
parameters through external
contact connector or RS232.
OUTPUT DB9–8 ON BATTERY* ( Default) [ON
BATTERY] [LOW BATTERY]
[BATTERY FAULT] [BYPASS]
[UPS OK] [LOAD PROTECTED]
[LOAD POWERED] [GENERAL
ALARM] [BAT CHARGING]
[OVLD PREALARM] [BAT
DISCONN]
Sets events or fault that will
actuate Output signal
parameters through external
contact connector or RS232.
33..66 CCoommmmuunniiccaattiioonn PPoorrttss
CCoonnnneeccttiinngg ttoo tthhee RRSS223322 oorr UUSSBB CCoommmmuunniiccaattiioonn PPoorrtt
9
10
17
18
Independent
Communication Bay USB RS-232
Any connectivity card Available
Any connectivity card Available
Available
Available
USB and RS232 are Independant
1. Connect the RS232 ⑰ or USB ⑱ communication cable to the serial or USB port on the computer
equipment.
Communication Ports