EasyManua.ls Logo

Eaton UPS 20 - Cabinet Installation

Eaton UPS 20
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13UPS 20-40 kVA, 230/400 V 50/60 Hz output
Users Guide
1025358
Revision D
5. Cabinet installation
The required distance for UPS units next to each other is ten millimetres. The same applies to
the optional battery cabinets that should be installed next to the UPS cabinet.
Figure 4 UPS and external battery cabinets.
Note!
UPS cabinets can fall over if the shipping brackets are not used. Both rear and front
shipping brackets must be used to secure the UPS cabinet to the floor.
The UPS family has several alternative battery cabinets and configurations depending on the
selected back-up time and quality of batteries.

Table of Contents

Related product manuals