P.53
PM10U
EBARA
CORPORATION
7.2.3 COMMUNICATION Start/Stop
a) START
Input the Main Pump “MP” start-up command from the RS232C
communication connector. The MP will start.
In the case of DIP SW A-8 ⇒ OFF : After “MP” rotation reaches 3000 rpm, “BP”
will start automatically.
In the case of DIP SW A-8 ⇒ ON : After “MP” rotation reaches 3000 rpm, input
the “BP” start-up command. BP will start.
The power is indicated on the display during pump operation. For other
status display indications, refer to Table 6.1.
[ NOTE ] The pump will not start when an WARNING/ALARM has been
generated. When a START signal is entered, "STARTFAIL" will
appear on the display.
b) STOP
Input the MP stop command from the RS232C communication connector. The
pump will stop.
Please refer to Communicating Specifications
To Next Page
Loading...
