Automatic running time calculation
Note
Automatic runtime calculation is not possible for air heaters.
The engine size entered can be increased by 500cm³ for a larger
heat requirement. If the combination valve 25.2014.80.6200 or
25.2014.80.7200 is used in the water circuit, the engine size
entered can be reduced by 500cm³.
The values for increasing or reducing the engine size entered
are only valid for cooling water circuits, whose vehicle fan heat
exchanger is flowed through before the vehicle engine.
If the vehicle is only used for short trips, consult the customer and
reduce the maximum runtime.
EasyStart Web undervoltage detection
– See PLUS installation instructions
Resetting EasyStart Web
– Reset to factory settings
Overview heaters
– Supported operating modes
– General operating hours counter
– Display current errors
– Read out and delete heater's fault memory
– Load fault memory
4.2.2 After completing the settings
Click the
or buttons to then save
or discard the configuration.
After ending the configuration, perform a test run in “Immediate
operation” mode.
Click the
button to start test mode.
Following the run through test operation is ended. To do this, select
the
button and then confirm the message.
The initial startup is completed.
Note
If errors were reported during the initial startup, determine the cause
of the error in Chapter 5 “What to do if …?” on page 12 first and
then carry out the described remedies.
When handing over the vehicle to the customer give them the pack-
aging box and quick start guide with the access code (IMEI).
22.1000.34.5106.0D EN | 06.2019 11
Operating instructions | EasyStart Web
To Next Page
Loading...
Need help?
General
