4 Initial startup / configuration
The web-based EasyStart Web operating software can be used to
operate an Eberspächer air or water heater via the installed receiver
unit.
Æ
The installation workshop or garage must log into the EasyStart
Web portal to start up the operating software.
4.1 Log in for initial startup
The initial startup of the EasyStart Web operating software can only
be carried out by the installation workshop using a PC / tablet with an
internet connection
.
To access the “EasyStart Web portal”, open the Eberspächer Part-
ner Portal with
https://partner.eberspaecher.com/de. If an access
to the portal already exists, it is not necessary to enter an email
address and password to log in. If no access exists yet, follow the
login instructions.
If the access is successful the main window of the partner portal
appears. Click the “EasyStart Web” button under the “Customer
Area” menu item.
Click here on the link to the B2B portal of EasyStart Web.
Select the “Initial startup” menu item.
Enter the approval code (IMEI) for EasyStart Web.
Note
The approval code (IMEI) is printed on the EasyStart Web packaging
box and is also enclosed in the packaging as a sticker.
4.2 Default settings for customers
Configure EasyStart Web as requested by the customer or as neces-
sary for installation.
Note
This step is only possible if the EasyStart Web registered on the
server beforehand (logged into a GSM network).
4.2.1 Configuring EasyStart Web
22.1000.34.5106.0D EN | 06.2019 9
Operating instructions | EasyStart Web
To Next Page
Loading...
Need help?
General
