Now go to the DDNS Status from step 3.7.2 and check if it says ‘succeed’. You should now be able to login to
the camera from remote access.
However, we showed you one example, there are many different kinds of routers, therefore it’s difficult to
show fixed steps for each router, but here are some other samples of different router’s port forwarding
settings. Remember, portforwarding.com is a very useful source of information.
TP-LINK:
1. Login the router.
2. Choose “Forwarding”, select “Virtual Servers”
3. Click the Add New button, pop-up below:
Figure 7.5
Fill the service port (except 80), IP address of the camera, then click Save
NOTE: The port and IP address should be the same as the Camera.
BELKIN:
1. Login to the router.
2. Choose “Firewall”, select “Virtual Servers”
3. Input the port (except 80) and IP address, then click save.
NOTE: The port and IP address should be the same as the Camera.
To Next Page
Loading...
